[Elecraft] ICE 419 interface

[Joe Subich, W4TV]

Yes, The ICE 419B requires pull to ground so the W9XT or 
Top Ten decoder will work directly.  With four 2.2 - 4.7K 
pull-up resistors, the W9XT decoder is the "low cost" 
solution. 

73, 

   ... Joe, W4TV 
 
  

> -----Original Message-----
> From: Andy Faber [mailto:andrewfaber at ymail.com] 
> Sent: Monday, December 01, 2008 3:11 PM
> To: microham at microham-usa.com; 'John Unger'; 'Elecraft Reflector'
> Subject: Re: [Elecraft] ICE 419 interface
> 
> 
> The TT Yaesu band decoder works fine.
>   73, andy, ae6y
> 
> ----- Original Message ----- 
> From: "Joe Subich, W4TV" <lists at microham-usa.com>
> To: "'John Unger'" <w4au at verizon.net>; "'Elecraft Reflector'" 
> <elecraft at mailman.qth.net>
> Sent: Monday, December 01, 2008 2:48 PM
> Subject: RE: [Elecraft] ICE 419 interface
> 
> 
> >
> > You need some kind of band decoder.  However, the W9XT 
> board (BCD to 
> > one of 9) will do the job nicely with the proper relay drivers.
> >
> > 73,
> >
> >   ... Joe, W4TV
> >
> >
> >
> >> -----Original Message-----
> >> From: elecraft-bounces at mailman.qth.net 
> >> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of John Unger
> >> Sent: Monday, December 01, 2008 8:09 AM
> >> To: Elecraft Reflector
> >> Subject: [Elecraft] ICE 419 interface
> >>
> >>
> >> I am in the process of connecting my K3 to a Model 419 ICE 
> bandpass 
> >> filter. Does anyone have a circuit or schematic of how they
> >> interfaced this filter
> >> with the outputs on the ACC port on the K3, or do I need a 
> full-blown
> >> solution like the KRC2 band decoder?
> >>
> >> tnx es 73 - John, W4AU
> >>
> >
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.): 
> > http://mailman.qth.net/mailman/listinfo/elecraft
> >
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> > 
> 
>