[Elecraft] K3- KRX3 and DVR Installation Sequence

[Stewart Baker]

On Thu, 28 Aug 2008 11:08:35 -0400, Barry N1EU wrote:
> On Thu, Aug 28, 2008 at 10:58 AM, Stewart Baker
> <stewart at baker.nildram.co.uk> wrote:
>> My experience is that although it only takes a minute or so to
>> remove the KRX3, it takes quite a lot of time to re-install. 
Most
>> of that time being taken up in routing the coax cables.
>>
> Only disconnect the KRX3 ends of the 3 TMP cables.  Just leave 
them in
> place and secure them out of the way with an alligator clip to 
the
> KPA3 shield.  To reinstall, just plug in the 3 cables and drop 
the
> KRX3 in.  It only takes a couple of minutes.

That's a good technique, must remember it for the next time.
>
> The speed of KRX3 reinstall is a moot point relative to the DVR 
since
> as Lyle described, you don't need to remove the KRX3 to install 
the
> DVR.  You just need to remove the front panel.

My front panel is getting quite a bit easier to fit with each 
removal and reinstallation :-)

73
Stewart G3RXQ


>
> 73,
> Barry N1EU
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com