[Elecraft] K3- KRX3 and DVR Installation Sequence

[Barry N1EU]

On Thu, Aug 28, 2008 at 10:58 AM, Stewart Baker
<stewart at baker.nildram.co.uk> wrote:
> My experience is that although it only takes a minute or so to
> remove the KRX3, it takes quite a lot of time to re-install. Most
> of that time being taken up in routing the coax cables.

Only disconnect the KRX3 ends of the 3 TMP cables.  Just leave them in
place and secure them out of the way with an alligator clip to the
KPA3 shield.  To reinstall, just plug in the 3 cables and drop the
KRX3 in.  It only takes a couple of minutes.

The speed of KRX3 reinstall is a moot point relative to the DVR since
as Lyle described, you don't need to remove the KRX3 to install the
DVR.  You just need to remove the front panel.

73,
Barry N1EU