[Elecraft] Prospective K3 Owner

[Greg - AB7R]

Drew wrote...

Some people pre-sort all the screws. I just dumped them and the
washers into a shallow pan and hunted through them as they were called
out. But do pay close attention to the screw lengths and washer types
specified in the instructions.

Very good point.  This is especially true when attaching the clear bezel over the 
LCD.  Use the wrong length screw and you will likely damage the LCD.  Just take 
your time and you will do fine.


-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065


On Tue Aug 26 14:13 , drewko1 at verizon.net sent:

>On Tue, 26 Aug 2008 13:09:04 -0700 (PDT), Joe W!JGS wrote:
>
>>
>>   - Are there any tools, over and above those mentioned in the assembly
>>manual, that would be helpful
>>
>
>Yes, a magnetized screwdriver is very handy for guiding the screws to
>their holes without having to fumble with them.  (There are a LOT of
>screws!)
>
>Some people pre-sort all the screws. I just dumped them and the
>washers into a shallow pan and hunted through them as they were called
>out. But do pay close attention to the screw lengths and washer types
>specified in the instructions.
>
>73,
>Drew
>AF2Z
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com