[Elecraft] KRX3 Assembly

[Jim Denneny]

Ordered KRX3 in June 2007.  Rcvd K3 s/n 453 Feb 08.  Rcvd KRX3 kit June 19. 
Completed KRX3 assy yesterday June 20.

Congrats to Elecraft for an excellent assembly manual.  I only wish my 
fingers were smaller to handle the 4-40 hardware in tight places but, it got 
done.

I had one scare when I fired it up after doing the startup routine.  I 
enabled sub rx but got error mesage attempting VCO CAL in sub mode.  I 
discovered I needed to update DSP2 firmware to V1.88 first.  After I did 
that, the VCO CAL in sub and filter setup went smooth.

Thanks again Elecraft

Jim 
K7EG