[Elecraft] 0.1" right angle header and sockets

[geoff allsup]

I've used SAMTEC straight sockets; assume they have right-angle too.

73,
geoff - W1OH

Kevin Rock wrote:
> I have been searching through Mouser and other catalogs for something I know exists.  I have seen examples in both Elecraft kits and in other kits I have built.  Now I want to find these parts for a project I am designing.  I want a set of 0.1" right angle header and sockets.  I am able to find the pin headers but cannot find the matching sockets.  Where do I find right angle sockets to mate with the 0.1" header pins?  I don't really want to change my design to use straight pins and sockets but may have to if I cannot find what I want.  Thus I am asking for direction: where do I find the parts I know exist?  I am probably not calling them the right thing but have tried a number of different names over the last four hours.  Any assistance would be appreciated.
>    Kevin.  KD5ONS
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 

-- 
*************************************************************
Geoff Allsup, W1OH     gallsup at whoi.edu  or  w1oh at whoi.edu
Research Engineer              Upper Ocean Processes Group
Woods Hole Oceanographic Institution   Woods Hole, MA, USA
*************************************************************