[Elecraft] 0.1" right angle header and sockets

[Jim Wiley]

Aren't the sockets always "straight", with the pins (the part that 
attaches to the PCB) either right angle or straight?  check pages 
1328-1329 of the Mouser Catalog 634 (May-July 2008) for a selection of 
3M connectors that will probably fill the bill. 


- Jim,  KL7CC





Kevin Rock wrote:
> I have been searching through Mouser and other catalogs for something I know exists.  I have seen examples in both Elecraft kits and in other kits I have built.  Now I want to find these parts for a project I am designing.  I want a set of 0.1" right angle header and sockets.  I am able to find the pin headers but cannot find the matching sockets.  Where do I find right angle sockets to mate with the 0.1" header pins?  I don't really want to change my design to use straight pins and sockets but may have to if I cannot find what I want.  Thus I am asking for direction: where do I find the parts I know exist?  I am probably not calling them the right thing but have tried a number of different names over the last four hours.  Any assistance would be appreciated.
>    Kevin.  KD5ONS
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
>