[Elecraft] K3: PA Jumper question

[Bob Cunnings]

Er, try PAIO ON and see!

Bob NW8L

On Sun, Aug 17, 2008 at 8:48 AM, Guy Hamblen <hamblen9 at optonline.net> wrote:
> My K3/100 #1394 did not have the PA Jumper installed on the RF Board.  I
> have installed the KPIO3 board which will act as a "jumper" without the PA
> installed.
>
>
>
> Previous discussion says to select PAIO Nor in the menu setup.
>
>
>
> Problem:  When selecting KPA3 with VFOB, there is no PAIO Nor in the menu
> with VFOA.  I have the following VFOA items:
>
>
>
> Not Inst, PAIO ON, PAIO Tst, PAIO FN1 thru FN4, PA Byp, PA Nor, PA FN1 thur
> FN4.
>
>
>
> What am I doing wrong?
>
>
>
> Thanks, Guy, N7UN/2
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>