[Elecraft] K3: PA Jumper question

[Bob Cunnings]

By golly, you're right - in recent firmware, PAIO nor seems to have
gone away, replaced by PAIO ON. I'll bet that it was changed because
of the constant confusion between PAIO nor and PA nor. Try PAIO nor
and see!

Bob NW8L

On Sun, Aug 17, 2008 at 8:48 AM, Guy Hamblen <hamblen9 at optonline.net> wrote:
> My K3/100 #1394 did not have the PA Jumper installed on the RF Board.  I
> have installed the KPIO3 board which will act as a "jumper" without the PA
> installed.
>
>
>
> Previous discussion says to select PAIO Nor in the menu setup.
>
>
>
> Problem:  When selecting KPA3 with VFOB, there is no PAIO Nor in the menu
> with VFOA.  I have the following VFOA items:
>
>
>
> Not Inst, PAIO ON, PAIO Tst, PAIO FN1 thru FN4, PA Byp, PA Nor, PA FN1 thur
> FN4.
>
>
>
> What am I doing wrong?
>
>
>
> Thanks, Guy, N7UN/2
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>