[Elecraft] K3 and amp

[Charles Harpole]

Why run an amp in anything but hi voltage position?

i.e., SSB switch.

In fact Alpha advised me directly to always run in

hi voltage position.  Life is too short.... etc.


Charles Harpole

k4vud at hotmail.com







> Subject: Re: [Elecraft] Possible added K3 feature
> From: brett at livecomputers.com
> To: mikekoetje at chartermi.net
> Date: Fri, 15 Aug 2008 20:26:18 -0700
> CC: elecraft at mailman.qth.net
>
> There already is a feature that allows you to set the SSB level slightly
> higher than that of the CW output.
>
> On Fri, 2008-08-15 at 19:06 -0700, N8XPQ wrote:
>> I was thinking that it would be nice to have a menu selection that would
>> allow you to select a power output by mode. This would enable those that use
>> an amp to easily switch modes Ex. SSB requiring slightly higher drive power
>> and CW requiring a lower drive level. We already have a menu option that
>> allows one to select power output by band. What does everyone think of this?
>>
>> Mike N8XPQ
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com