[Elecraft] K3 - configure RX/TX equalizer using macros

[GM0ELP]

I was just about to post comments about the implementation of the RX
EQualiser when I came across Thomas's post below. I'm now using the elecraft
k3 utility program (command tester) to hop quickly between RX EQ settings on
the K3....brilliant, thanks! Here are some cw suggestions to try:

CW RX FLAT
AI0;K31;MN008;SWT53;MN255;K30;

CW RX 400Hz
AI0;K31;MN008;SWT53;SWT24;DN;DN;SWT27;UP;UP;UP;SWT29;DN;DN;DN;DN;DN;MN255;K30;

CW RX 1000Hz
AI0;K31;MN008;SWT53;SWT12;DN;DN;DN;SWT13;DN;DN;SWT24;DN;SWT27;UP;UP;UP;SWT29;DN;DN;DN;DN;DN;MN255;K30;

The 400/1000 (bandwidth) settings both peak the audio response for pitch
settings in the 700-800Hz range and have the effect of 'brightening' any cw
sig in that window. You can then switch back to FLAT to quickly compare the
difference.

I mainly use CW and am interested in what RX EQ settings everyone else is
using. 

73 Doug GM0ELP


-- 
View this message in context: http://n2.nabble.com/K3----configure-RX-TX-equalizer-using-macros-tp465559p684019.html
Sent from the Elecraft mailing list archive at Nabble.com.