[Elecraft] Low battery on K2 without battery

[Ken Wagner K3IU]

Oops... I just noticed that you had already mentioned that.
Sorry...
73,
Ken K3IU
~~~~~~~~~~~~~~~~~~
Ken K3IU wrote:
> Scott:
>
> You might also check to see that the shorting block on P7 on the 
> Control Board is in the correct position. If you have it in the EXT 
> position, then, if I remember correctly, you will get the Low Battery 
> warning.
>
> 73, Ken K3IU
> ~~~~~~~~~~~~~~~~~~~~~~~~~
>
> Scott McDowell wrote:
>> Hello
>> For some reason the low battery messages keeps poping up on my K2
>> in the receive mode.
>> I have the p7 jumper on the internal side, and have tried it on the
>> external pins, but I still keep getting the low battery message.
>> On my first K2 I  had the battery deal turned off, but don't see 
>> anything
>> in the manual on how to turn it off on this one.
>> It's drawing 240 ma on receive and the internal volt meter doesn't work
>> but the power supply voltmeter shows 13 volts.
>> Any ideas?
>> Scott
>> N5SM
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>  http://mailman.qth.net/mailman/listinfo/elecraft   
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>>   
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>