[Elecraft] Low battery on K2 without battery

[Ken K3IU]

Scott:

You might also check to see that the shorting block on P7 on the Control 
Board is in the correct position. If you have it in the EXT position, 
then, if I remember correctly, you will get the Low Battery warning.

73, Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~

Scott McDowell wrote:
> Hello
> For some reason the low battery messages keeps poping up on my K2
> in the receive mode.
> I have the p7 jumper on the internal side, and have tried it on the
> external pins, but I still keep getting the low battery message.
> On my first K2 I  had the battery deal turned off, but don't see anything
> in the manual on how to turn it off on this one.
> It's drawing 240 ma on receive and the internal volt meter doesn't work
> but the power supply voltmeter shows 13 volts.
> Any ideas?
> Scott
> N5SM
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>