[Elecraft] [K3] clarification on VFO and 2nd Rx - erratum

[Don Wilhelm]

David,

I think the real answer to those extensions will have to wait until 
after the KRX3 ships.  I really don't know how RTI and XIT interact with 
the sub-receiver, nor have I though about how to best utilize it in 
situations like you have posed.

73,
Don W3FPR

David Ferrington, M0XDF wrote:
> Arrrgggghhh
>
> For RIT below, read XIT
>
>
> Thank you Don, I kinda thought that was how it was and in typing the mail,
> came to realise I need to think in terms as you stated. So then I just
> wanted clarification.
>
> I have on more question then - lets say I have the KRX3 (I will when it
> ships :-). I'm working a split DX, there's one hell of a pile-up (must be
> 3B7C again). I'm using diversity receive, so I can hear both the DX freq and
> their QSX, I want to transmit 300 Hz higher than I'm listening to on the Sub
> - how does one do that quickly?
>
> Perhaps use RIT on the SUB, is that possible - i.e., press [B SET] and set
> RIT to be 300Hxz higher?
>
> Then lets assume I don't work them, but want to check if they did listen
> around where I transmitted, can I then press [REV] and while keeping it
> depressed, HOLD [CLR] to add the RIT to the SUB freq and clear the RIT?
>
> I know these are things I'll be able to figure out once I get the K3, but I
> got to do something while I'm waiting for the Big Brown Van
>
> On 16/10/07 14:18, "Don Wilhelm" <w3fpr at embarqmail.com> sent:
>
>   
>> David,
>>
>> It may help if you mentally divorce the physical VFOs from the A and B
>> designations and think of the DISPLAYED frequencies.
>>     
>
>
>