[Elecraft] [K3] CW via serial cable question

[Julian G4ILO]

I use MixW and I was not aware that it directly supported K2 KY
keying. The macros do have support for direct entry of CAT commands,
and you can use that facility to send raw KY commands to the K2.
Perhaps that is what you meant. It would allow the facility to be used
to send fixed text, just like keyer memories, but you cannot insert
variables from the log like the other station's call or an incremented
serial number, nor is it usable to send text typed in real time.

Because you are limited by the K2 protocol to how many characters you
can send at a time, and must poll the buffer until it is ready before
you can send more, you can't use this method to send very long texts.

On the other hand, perhaps they have added support in a recent update
and I wasn't aware of it?
-- 
Julian, G4ILO K2 s/n: 392  K3 s/n: ???
G4ILO's Shack: www.g4ilo.com
Zerobeat Ham Forums: www.zerobeat.net/smf


On 10/15/07, Don Nesbitt <drnesbitt at bellsouth.net> wrote:
> Hi Dave - the only software that I found that directly supported this in the
> K2 was the MixW (http://www.mixw.net/) program.  As I recall, it directly
> supported the "KY" (could have that nomenclature wrong) commands for keying.