[Elecraft] [K3] CW via serial cable question

[Don Nesbitt]

Ed - my understanding is that N1MM does NOT support the "KY" command set.  I
too use N1MM to key through the serial port but use a simple single
transistor switch to do it.

The "KY" command set would allow one to key WITHOUT any additional "keying"
circuit.  See page 309 of the N1MM Logger manual released on 7-10-2007 -
under Supported Radios - Section 50.3 Elecraft for a reference.  73 -- Don
N4HH

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ed K1EP
Sent: Monday, October 15, 2007 5:42 AM
To: vk2nu at bigpond.net.au; elecraft at mailman.qth.net
Subject: Re: [Elecraft] [K3] CW via serial cable question

<SNIP>
>
>I've been reading about the ability of the K3 to have CW sent on the 
>serial cable used for rig control. From memory this was possible on 
>the K2 but most 3rd party logging/contest programs didn't support this.

<SNIP>

I was using this feature over the weekend to send CW using the serial 
cable line.  I was using N1MM logger with my K3.