[Elecraft] Can't acess KDSP2 menus...

[Steve Kallal]

I'm looking at page 24 of the KDSP2 manual. In the "KDSP2 Primary Menu"
section it says:

----------------------------------------------------------------------------
----------------
In SSB or CW modes, the primary menu is used for the auto-notch and noise
reduction functions. In
RTTY, the primary menu is the Filters menu, described below.

>From the primary menu, you can toggle the noise reduction adaptive filter
(generally referred to as a "denoiser" and, in the SSB mode, the auto-notch
filter. You can also adjust the denoiser's level from 1 (least aggressive)
to 4 (most aggressive).

Let's assume you were in SSB mode using filter 2. Tap the DISPLAY button to
bring up the primary
menu in the K2 display:

S2 nr nt
----------------------------------------------------------------------------
----------------

At this point I don't get the results shown the manual. If I'm in the menu,
I toggle to between Pri and Sec. Otherwise I get the voltage and current
readings.

Is there something wrong with the manual? What am I doing wrong? Where is
the filters menu?

Help!!!

73,

Steve N6VL
K2 #2289