[Elecraft] Re: [N1MM] Elecraft K3 with N1MM

[Tom Hammond]

Folks:

This is a response to a message posted on the N1MM Logger reflector, 
but since it's
K3-related, I'm posting to Elecraft as well...

At 07:30 10/06/2007, lu_w4lt wrote:
>Anyone using an Elecraft K3 with the software?
>Any issues or praise?
>I am considering a station upgrade.
>Thanks in advance
>Lu - W4LT
>
>At 10:29 AM 10/6/2007, Jim Denneny wrote:
>Since factory has not shipped K3 yet,
>answer is no (other than a few beta testers).
>Jim K7EG

Up until about 5-6 days ago, the K3 was not able to communicate
with N1MM in BOTH directions... it could RECEIVE (and act upon)
commands from N1MM, but N1MM was not able to get info FROM the K3.

That's all changed now, and I'm helping test N1MM LOGGER on the
K3 and so far it's working quite well.

NO KNOWN STUMBLING (SIGNIFICANT) BLOCKS SO FAR SINCE THE COMMS
PROBLEM HAS BEEN ELIMINATED...!

N1MM may not have FULL K3 functionality installed quite yet.
K3CT is working with Elecraft and the FTs to get all the functionality
installed, but this takes time.

I have full faith in John's abilities however.

I'm hoping to try N1MM Logger a bit later today in the Cal QSO Party
and then again next weekend in another 'activity' as well. Will report
if I find ANY show stoppers.

73,

Tom Hammond   N0SS   K3 Field Tester