[Elecraft] XV144 problem - no LEDs light up

[Don Wilhelm]

John,

Did you set up R10 properly?  See page 28 of the new XV User's Manual 
for instructions.  You may download the manual if you have an older one. 
(I am certain it is in the older manual too, just not certain where).

73,
Don W3FPR

>
> I've just resurrected my XV144 after a year of none use. I needed to 
> make up a new cable for the K2 to the XV. Everyting seems norml except 
> that the LEDs are not lighting on transmit. As the relays operate, one 
> bar flicks on and then goes off. I am getting about 15 watts output 
> and it is receiving OK. I've checked the wiring on the main connector. 
> The K2 is set to trn2 and is reading the correct frequency on 144mhz. 
> Have I missed or forgotten something obvious?
>