[Elecraft] K3 Mic MH2 on K2

[Don Wilhelm]

Bernie,

In that case, build an adapter.

73,
Don W3FPR

Bernard Gaffney, N8PVZ/QRP wrote:
> Don,
> 
>   thanks for the reply. I may not have been clear in
> my original Post, but what I want to do is have the
> mics be interchangeable; i.e., be able to use either
> mic on either rig, not just on a specific rig. Sounds
> like that may not be possble, based on your reply?
> 
>     72 de N8PVZ
>        ---bernie
> 
> --- Don Wilhelm <w3fpr at earthlink.net> wrote:
> 
>> Bernie,
>>
>> It may be even easier than that - if you do not use
>> the MC-60 mic on a Kenwood transceiver, then you 
>> can re-wire the 8 pin mic plug - just move the wire
>> currently connected to pin 5 to pin 6.  If
>> there was something already connected to pin 6, you 
>> will want to remove it (and you will  lose the 
>> function of whatever it accomplished).
>>
>> Since the Kenwood mic does not want a resistor
>> between 5 volts and pin 1 (AF), you must install 
>> that resistor in the MH2 mic plug rather than 
>> across the mic jack inside the K2.  That action will
>> dedicate the MH2 mic to YOUR K2, but that may be OK 
>> unless you try to sell the mic.
>>
> 
> 
>  
> ____________________________________________________________________________________
> 8:00? 8:25? 8:40? Find a flick in no time 
> with the Yahoo! Search movie showtime shortcut.
> http://tools.search.yahoo.com/shortcuts/#news
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
>