[Elecraft] K2 #6155 Different Front Panel Resistance Check value

[Bernie Gardner]

That sounded familiar.  I looked back at my first post to the list which was 
essentially the same question. I got 22.5 instead of your 22.6.  The response 
was that it was ok, and in fact the radio has been fine.  Between component 
variation and voltmeter accuracy I guess the allowable range in the manual 
should be a little larger.

Bernie
W1AZ


On Tuesday 26 June 2007 22:22, Arthur Gunn wrote:
> This reflector is a valuable first stop in troubleshooting.
>
> Is there any experience with the accuracy of the resistance value stated
> in the manual, for resistance measured at the U1 pin 2 (and same values
> for J1 pins 16 & 17) to ground as 22.6 kOhm rather than the suggested
> range of 25 - 35 kOhm? There are many paths for the resistance after the
> easily found R6 & R7 (values as indicated on resistors) and the
> troubleshooting will be interesting if there is a problem.
>
> Is the value given on the manual page 28 correct to your measurements?
>
> Thanks for your experience.