[Elecraft] K2 #6155 Different Front Panel Resistance Check value

[Arthur Gunn]

This reflector is a valuable first stop in troubleshooting. 

Is there any experience with the accuracy of the resistance value stated
in the manual, for resistance measured at the U1 pin 2 (and same values
for J1 pins 16 & 17) to ground as 22.6 kOhm rather than the suggested
range of 25 - 35 kOhm? There are many paths for the resistance after the
easily found R6 & R7 (values as indicated on resistors) and the
troubleshooting will be interesting if there is a problem.

Is the value given on the manual page 28 correct to your measurements?

Thanks for your experience.
-- 
Arthur VE9BP