[Elecraft] K2 SSB Option RP3 Question

[Don Wilhelm]

Clark,

You must be doing an inventory for the control board - the front panel 
has no RP3 and the RF Board has the thermistor board in place of RP3.

On the R-Paks, the last 3 digits of the number on the body are 
significant.  In the case if CB RP3, it is 47k ohms, so look for a '473' 
at the end of the number - that is 2 significant digits (47) plus a 
multiplier (3).

The number you quoted either was incomplete or is a component 
manufacturer's designation and has no relationship to the Elecraft part 
numbers.

73,
Don W3FPR

Clark Macaulay wrote:
> I'm buidling my K2 purchased at Dayton and found a problem when doing a parts inventory.  The Parts List designator for RP3 is far different than the part I received: it says 806345.  Does anyone know if this is a acceptable substitute?  There's nothing in the manual/Addenda nor in the reflector archives.
>