[Elecraft] K2 #6155 Resistance check for Assembly II - U6 pin 9 low value

[Arthur Gunn]

Hi builders

Progress seems fine except for a 36 ohm value measured at U6 pin 8
instead of >100 ohms (page 59). What values have you seen there? My
measurements were made with an Ideal auto-ranging DMM.

I see at least 8 paths plus active devices to be considered for
troubleshooting if 36 ohms is not a commonly seen resistance reading.
The other values in the table of resistance checks are as specified.

I look forward to hearing your experiences at this resistance
checkpoint.
-- 
Arthur VE9BP