[Elecraft] Front Panel Board K2 06014 wheres RP3 10K 8 pin

[w6fvi]

And this will only get more confusing before it gets better. 

There are actually two references of RP3 on page 3 of the Parts list.  
The first is line 1, as you have found.  The second one is on line 18 
(or line 4 under the heading "Components on Front Panel Board").  There 
is where you'll find your 10K, 8 pin resistor pack listed.

Of course, this is all moot if you don't actually have an 8 pin resistor 
pack in your kit!  For that you should contact parts at elecraft.com and 
ask for part #E510005.

Brian, W6FVI
Elecraft Support


glblock at mchsi.com wrote:

>Ok, confused here.  On page 28 of the Owners Manual it says to check off the
>items NOT installed.  If I have the SSB kit, which I do, it says to install them
>now.
>
>RP3 has some issues.. it says its a 10k resistor network and is supplied in the
>SSB kit.  The board shows it as an 8 pin inline part.  The SSB parts had all the
>parts BUT describes RP3 as a 2K 6 pin resistor network AND there is NO 10K
>inline pin resistor chip in the SSB bag to put in the front panel board.
>
>What goes in the RP3 slot on the Front panel board.  In the SSB manual it
>describes RP3 as a 10K 8 pin but on page 3 RP3 is a 2.0K 6 pin ???
>
>confused..
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com
>
>
>  
>