[Elecraft] 8v tx voltage

[Jesus L. Paleo]

Jesus L. Paleo wrote:
> Hello all, i am in the adjust phase of build my K2. My main problem 
> not solved yet is that 8V tx voltage line is with 5.1 v permanet. 
> Microprocesor tx order is down and rx is up, so here all is rigth, 
> colector of Q1 is with 5.1. Also RX voltage seem to be down, not 8V 
> but 6.5. Receiver work, i receive the signal from a external 
> generator, but display not show agc indicator. Calibration of display 
> also seem to work fine. Can someone ligth me in a good direction, Thanks.
>
> Jesus, EA1DAV.

SOLVED!

The mistake was in the antena PIN diode switch, D1 was reversed. Sorry 
by the noise in the list and thanks by all answers.
I continue the adjust, hope no more like this ;-)

Regards.

> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com