[Elecraft] K1-4 RF board (C8)

[Jay M.]

I didn't see this when I searched the reflector and archives, so I may just
be the first not to get this...

I'm about to install C8 on the bottom of the RF board.  The instruction
reads "Before soldering, fold it down against the board, towards the back."

First, my 82 pF is labeled '820.'  Assume this is correct, but can someone
confirm?

Second, if I fold it down toward the "back," it looks like I'll the two
holes between C8 and C17.  Is this correct?  If so, is it important that I
leave enough lead length to bend it over past the holes so I don't block
them?

Thanks!

Jay M.
-- 
View this message in context: http://www.nabble.com/K1-4-RF-board-%28C8%29-tp14563103p14563103.html
Sent from the Elecraft mailing list archive at Nabble.com.