[Elecraft] Re: K3 and N1MM Logger

[Paul]

Thanks to all of those who answered on and off the list. It is working 
now. The configuration that is working for me is:
On the K3 - PTT-KEY is set to Off-dtr
N1MM is set to CW for DTR and always off for RTS.
I am able to key via the paddles and/or N1MM.

73,

:) PK (Paul - K3MZ   K2 #3135  K3 #84)

Paul wrote:
> I can get N1MM to see the K3. I am switching logging software, for the 
> K2 I used WriteLog. The frequency and mode show in the title bar for 
> N1MM.  However, I can NOT get N1MM  to send CW. to the K3. I see the 
> software thinking it is sending the CW (the stop light gets bright and 
> then dims).
>
> I am using a serial cable connected to the only serial port on the 
> computer running Windows XP. This same cable and port were able to 
> load the firmware. For the N1MM configuration I have set Com1 to 
> Elecraft K3, and the CW/Other box is checked. In the parameters for 
> this port, I have DTR set to CW and RTS set to Always on. I have tried 
> other combinations for the DTR and RTS settings and none seem to work. 
> The CW/PTT port address is 3F8.
>
> I appreciate guidance from those who have made this work.
>
> 73,
>
> :) PK (Paul - K3MZ   K2 #3135  K3 #84)