[Elecraft] K3 and N1MM Logger

[Van W1WCG]

Paul,

The settings you give are identical to what I'm using, however you didn't
mention setting the K3 CONFIG parameter PTT--KEY to OFF - dtr.
This will match the settings you have in N1MM logger.

73, Van W1WCG
K3 #42

----- Original Message ----- 
From: "Paul" <konigsburg at aol.com>
To: <Elecraft at mailman.qth.net>
Sent: Thursday, December 13, 2007 1:38 PM
Subject: [Elecraft] K3 and N1MM Logger


>I can get N1MM to see the K3. I am switching logging software, for the 
> K2 I used WriteLog. The frequency and mode show in the title bar for 
> N1MM.  However, I can NOT get N1MM  to send CW. to the K3. I see the 
> software thinking it is sending the CW (the stop light gets bright and 
> then dims).
> 
> I am using a serial cable connected to the only serial port on the 
> computer running Windows XP. This same cable and port were able to load 
> the firmware. For the N1MM configuration I have set Com1 to Elecraft K3, 
> and the CW/Other box is checked. In the parameters for this port, I have 
> DTR set to CW and RTS set to Always on. I have tried other combinations 
> for the DTR and RTS settings and none seem to work. The CW/PTT port 
> address is 3F8.
> 
> I appreciate guidance from those who have made this work.
> 
> 73,
> 
> :) PK (Paul - K3MZ   K2 #3135  K3 #84)
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com