[Elecraft] K3 and N1MM Logger

[Paul]

I can get N1MM to see the K3. I am switching logging software, for the 
K2 I used WriteLog. The frequency and mode show in the title bar for 
N1MM.  However, I can NOT get N1MM  to send CW. to the K3. I see the 
software thinking it is sending the CW (the stop light gets bright and 
then dims).

I am using a serial cable connected to the only serial port on the 
computer running Windows XP. This same cable and port were able to load 
the firmware. For the N1MM configuration I have set Com1 to Elecraft K3, 
and the CW/Other box is checked. In the parameters for this port, I have 
DTR set to CW and RTS set to Always on. I have tried other combinations 
for the DTR and RTS settings and none seem to work. The CW/PTT port 
address is 3F8.

I appreciate guidance from those who have made this work.

73,

:) PK (Paul - K3MZ   K2 #3135  K3 #84)