[Elecraft] [K3] Assembly

[Craig Rairdin]

You should be fine unless you're storing a copy of the firmware on a floppy
disk near your assembly area. ;-)

Craig
NZ0R

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of David Pratt
Sent: Sunday, December 09, 2007 12:19 PM
To: Elecraft Reflector
Subject: Re: [Elecraft] [K3] Assembly


In a recent message, Corboy-Poteet <disorder at sbcglobal.net> wrote ...
>This may be common sense and/or mentioned in the Assembly Manual but:
>if your Phillips screwdriver does not have a magnetized tip it would
>be a good idea to find a magnet and lightly magnetize the tip.

Ah, but mind you don't erase the firmware ;-)

73
-- 
David G4DMP
Leeds, England, UK
------