[Elecraft] K3 Calibration Problem

[Sanger, Joseph]

Thanks for the tip, Craig.  

But I am using the standard 2.7KHz filter for these calibrations.
(Indeed, the problem seems to be essentially independent of the filter
or mode chosen.)

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Craig Rairdin
Sent: Saturday, December 01, 2007 2:19 PM
To: elecraft at mailman.qth.net
Subject: RE: [Elecraft] K3 Calibration Problem

> The real problem is that after setting the power to "exactly
> 5.0 watts" and holidng TUNE, the power reading on 160 meters only 
> goes to 1.2 watts; when I tap TUNE to exit, VFO B says: ERR TXG.  
> Similar problems on other banads, to wit:  1.8 Watts on 80m, 1.4 
> Watts on 40m, 1.9 Watts on 20m, etc.

Make sure you've selected a filter that is at least 1 khz wide for CW
transmit. Otherwise you'll get the ERR TXG message.

Craig
NZ0R
K3/100 #25

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

------------------------------------------------------------
This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email.
=================================