[Elecraft] OT: Miniature screwdriver sizes

[Dave W7DPW]

I had to purchase some odd sizes of Phillips drivers and found a good
selection at SEARS.  They had them listed by the numbers

Dave


David J Drew  --  W7DPW
Over 50 Years with Same Call
Amateur Extra Since 1970
Continuous ARRL Member Since October 1957
ARRL Life Member October 1969
Vancouver, Washington  98664-4445




----- Original Message ----- 
From: "Mike" <mike.fairleigh at comcast.net>
To: <elecraft at mailman.qth.net>
Sent: Wednesday, August 29, 2007 4:00 PM
Subject: [Elecraft] OT: Miniature screwdriver sizes


> I'm in need of a very small phillips screwdriver, but haven't been
able to find actual dimensions of them and I don't know what size a "#0"
would be, etc.  I thought someone on this board might have some advice.
The slots in these screws are .064" or 1.63mm.  Any help would be
greatly appreciated!
>
> --
> 73,
> Mike, KC0KBC
> Yaesu FT-857D, FT-8800R, VX-7RB
> Elecraft KX1 #1819, XG2
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com