[Elecraft] K3 Receiver Antenna Routing

[Gary Hvizdak]

The second paragraph from the bottom one page 1 reads ...

Relay K1 allows the subreceiver to share the main receiver's RF source, or
use its auxiliary RF input.  This means that two receiving antennas could be
used. But it's also possible to route a single receiving antenna to both the
RX ANT IN and AUX RF jacks using a "Y" adapter.  This would allow the
subreceiver to use the antenna connected to RX ANT IN even if the main
receiver were using ANT 1.  No external splitter is required because only
one of the receivers will be connected to the receiving antenna at a time.

--

Wayne,

I don't understand the last sentence in the above paragraph.  Am I missing
something here?

TXN,
Gary  KI4GGX