[Elecraft] FS: K2/100

[NZ8J]

I have 2 K2's and I've decided to sell the K2/100 and keep the K2. Here
is what I have:

K2/100 - serial #5163 (all latest firmware)
KDSP2 - DSP unit
K160RX - 160m and rx ant module
KNB2 - noise blanker
KSB2 - SSB unit
MH2 - Hand Mic ( this is the new model just purchased in July)
QRP cover with the speaker
Rework eliminators for the installed optional modules (ssb, nb, 160,
dsp)

I have all the manuals and misc accessories.  

The radio has an intermittent problem in that when cycling through the
bands sometimes on 160 the receive is low, cycling to 10 meters or 80
meters and then back to 160 will usually bring the rx back, sometimes it
takes a couple of cycles.  I had originally thought there was a problem
on the rx dropping out on other bands, (see my post to the list on
7/27/07) but after taking the pa unit off and reseating the modules,
etc, the only problem I find now is the 160 meter problem. I don't know
if it had anything to do with the problem on the other bands, but D19 in
the SEC menu was set to ON, I set it to OFF right after I checked the
modules.

 I have not used the radio on ssb, I bought the new MH2 mic with the
intention of setting it up, but I have not got around to taking the
boards out to configure the mic connector on the radio with the required
resistor, etc.  The parts are all with the new mic, it has never been
used. I was told the radio is currently configured for a Kenwood mic.

I have used the radio on CW extensively and it works great.  The power
output  ranges from 115 watts on 160 meters to about 85 watts on 10
meters. 

The kit prices for everything would be $1483 not including the shipping.
Due to the minor intermittent problem on 160 rx and the fact that I
cannot vouch for the ssb operation I will ship and insure everything
listed  AS-IS for $775 firm in the US only. That's just a little more
than half the price of the kits alone.

If you have any questions please ask.

73
Tim
NZ8J