[Elecraft] K2 SSB microphone connection

[Mike Geddes]

Ugh-h-h!  Been trying to do Tom's (N0SS) microphone configuration header for 
P1.  After hour and a half I figure there must be a better solution!  Maybe 
my connectors were not very good quality . . . but had trouble keeping the 
wire in, tabs breaking, blah blah blah.  Messed up the two connectors I had 
in the process. I like the idea but it is just not working for me.  I tried 
using the flat cable wire as Tom suggested, then some small hookup wire I 
had . . . and had no luck on either.  The hookup wire had some 
possibilities, but I soldered one jumper in and it blocked others, etc. 
Guess I may be just impatient tonight.

I am about ready to use Electraft jumpers and just rewire the mike 
connection. Any ideas or suggestions are welcome.

73,
Mike
N4JX

K1/4  2319 on the air
K2    6042 on the air