[Elecraft] XV144 paired with Uniden HR-2600?

[Siu Johnny]

Hi Cathy,

If you are only using XV144 for RX mode, you don't have to do any 
modification.  Even you use XV144 for any non K2 transceiver, the 
connection is also simple.  The XV144 operation manual listed out all the 
connection possibilities.

My K2 does not have any of the KIO2 or K60XV, the connection is based on 
the diagram related to non K2 transceiver.  The operation manual gives very 
detail connection method.

I do not think any modification for your Uniden is required.

73

Johnny Siu VR2XMC


From: Cathy James <prjames at mindspring.com>
To: elecraft at mailman.qth.net
Subject: [Elecraft] XV144 paired with Uniden HR-2600?
Date: Thu, 19 Oct 2006 19:40:34 -0500


Folks,

    I am interested in building the XV144 transverter.  However, I do not 
want to tie up the K2 as the IF.  Instead, I have a Uniden HR-2600 
(unmodified) lying around that I'd like to use for the IF/tuner/etc.

    Has anyone out there used the 2600 or 2510 as the IF for the XV144?  
How difficult is it to do this?  Reading thru the XV144 manual with regard 
to separate TX/RX cables, PTT cables to trigger the XV, blah blah, makes me 
a bit nervous.  Am I going to have to modify the Uniden?

Any suggestions would be appreciated.

Cathy

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

_________________________________________________________________
ÏíÓÃÊÀ½çÉÏ×î´óµÄµç×ÓÓʼþϵͳ¡ª MSN Hotmail¡£ http://www.hotmail.com