[Elecraft] KX-1 dead :(

[Don Wilhelm]

Tod,

Ok, you have an open circuit somewhere between the power supply and the
anode of D2 - there are only a few pieces involved - the wire in the power
cable, the male connector, the female connector in the KX1 and a bit of PC
board trace going from the connector to the anode of D2.  Continue the
continuity testing on each piece and possibly through the mated connectors -
sometimes connectors will fail to mate properly if one of then does not have
adequate spring tension in the contacts.

You likely do not have a dead KX1, but you do have a dead power connection
somewhere along the line.

73,
Don W3FPR


> -----Original Message-----
>
> There's no continuity between + and the D2 anode
>
>