[Elecraft] Rework Eliminators

[Tom Zeltwanger]

OK I just have to ask:
What the heck are Rework Eliminators? 

I am just starting a K2/100, and will be building it for some time. In the mean
time, I have been watching this list (an outstanding resoucer, I might add), and
Rework Eliminators come up from time to time. I am dying to know what they are,
and if they are something I need to help with my move into K2 land.

73,

Tom KG3V


Quoting Don Wilhelm <w3fpr at earthlink.net>:

> Scott,
> 
> Do not install anything at C167.  With the Rework Eliminators, you should
> find a header for J11 - install that, and the jumper they are referring to
> is on the board that plugs into that J11 header.
> 
> 73,
> Don W3FPR
> 
> > -----Original Message-----
> >
> > HI
> > I'm a little confused, which is not unusual for me, on the last
> > item on page 50 of the assemble manual for the K2.
> > It says - Install C167 (.001 uf "102") which is near J11, the
> > connector for the SSB adapter. The leads on this capacitor should
> > be formed to match its PC board outline.
> > The un-module manual say don't install C167 and install a jumper
> > at J11.
> > I'm inclined to believe that it is saying to install a jumper instead
> > of C-167. Is this correct. Sure would hate to smoke a PCB by putting
> > a jumper where it shouldn't be.
> > Any help would be appreciated.
> > Scott N5SM
> >
> >
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>