[Elecraft] k2--C167

[wsm at amaonline.com]

HI
I'm a little confused, which is not unusual for me, on the last
item on page 50 of the assemble manual for the K2.
It says - Install C167 (.001 uf "102") which is near J11, the 
connector for the SSB adapter. The leads on this capacitor should
be formed to match its PC board outline.
The un-module manual say don't install C167 and install a jumper
at J11. 
I'm inclined to believe that it is saying to install a jumper instead
of C-167. Is this correct. Sure would hate to smoke a PCB by putting
a jumper where it shouldn't be.
Any help would be appreciated.
Scott N5SM