[Elecraft] LCD Diffuser SPACERS? K2 # 5422?

[Peter - PAøPJE]

Oh and btw, Fred,
This is on the same page;

<quote>

Locate the Spacer Set PC board (Figure 5-1). Using long-nose

pliers, carefully break out the pushbutton switch spacing tool and

the four backlight LED spacers. Break the material only at the four

indicated points. Note: The switch spacing tool doubles as the PC

board for the RF probe, which will be assembled later.

<unquote>

73,

Peter



----- Oorspronkelijk bericht ----- 
Van: "PAøPJE" <pa0pje at doge.nl>
Aan: <Elecraft at mailman.qth.net>
Verzonden: zaterdag 25 maart 2006 17:47
Onderwerp: Re: [Elecraft] LCD Diffuser SPACERS? K2 # 5422?


> Fred,
>
> They are part of the pieces PC board that is seen in fig. 5-1
> That is the switch spacing tool. Part of it are the spacers.
>
> 73,
> Peter PA0PJE
>
> F and J schreef:
>> I'm building K2 #5422, doing Front Panel board now!
>>
>> I seem to be MISSING the two (2) 3/4" (19mm) LONG
>> SPACERS mentioned on page 26, for putting over leads
>> of each backlight LED shown in figure 5.9?
>>
>> No were to be found, as far as I can see.  WHAT DO
>> THEY LOOK LIKE?  Paper?  Plastic?  Temporary?
>> Home made?
>>
>> There are no "spacers" mentioned in appendix of
>> photos for this Front Panel PCboard either?
>>
>> Help
>> Thanks, 73's
>> Fred N3CSY
>> Spring Hill, FL
>>
>> __________________________________________________
>> Do You Yahoo!?
>> Tired of spam?  Yahoo! Mail has the best spam protection around 
>> http://mail.yahoo.com _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>  http://mailman.qth.net/mailman/listinfo/elecraft    Help: 
>> http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com