[Elecraft] LCD Diffuser SPACERS? K2 # 5422?

[PAøPJE]

Fred,

They are part of the pieces PC board that is seen in fig. 5-1
That is the switch spacing tool. Part of it are the spacers.

73,
Peter PA0PJE

F and J schreef:
> I'm building K2 #5422, doing Front Panel board now!
> 
> I seem to be MISSING the two (2) 3/4" (19mm) LONG
> SPACERS mentioned on page 26, for putting over leads
> of each backlight LED shown in figure 5.9?
> 
> No were to be found, as far as I can see.  WHAT DO
> THEY LOOK LIKE?  Paper?  Plastic?  Temporary?
> Home made?
> 
> There are no "spacers" mentioned in appendix of
> photos for this Front Panel PCboard either?
> 
> Help
> Thanks, 73's
> Fred N3CSY
> Spring Hill, FL
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>