[Elecraft] KAT100 RFC2 core.

[Joe-aa4nn]

Stephen,
You should check very carefully the cores you used previously
to make sure they are correct.  The cores you use MUST be
as indicated in the builder's manual.
de Joe, aa4nn'

----- Original Message ----- 
From: "Stephen Okolita" <one20out at yahoo.com>
To: <elecraft at mailman.qth.net>
Sent: Tuesday, July 25, 2006 4:37 PM
Subject: [Elecraft] KAT100 RFC2 core.


> So I'm building a KAT100 tuner and everything is going
> along fine until I get to T1 and RFC2.  According to
> the manual T1 is supposed to be wound on a FT50-43
> core (.5 in.) and RFC2 on an FT37-43 core (.37 in.). 
> Unfortunately all I have left in the kit are two .5
> inch cores, one dark grey, the other painted red.  So
> I'm planning on winding T1 using the dark grey .5 in.
> core.  Do any of you experts out there think there
> would be any harm in winding RFC2 on a slightly larger
> core (.5 in. red)?  Or should I go back to Elecraft
> and wait for a replacement?  
> 
> Your input is appreciated.
> 
> Stephen
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>