[Elecraft] Fwd: KAT100-1 Measurements?

[Darrell Bellerive]

Thanks very much to all who have replied!!!

Here is the average of the measurements for the archive:

On July 23, 2006 03:48 pm, Darrell Bellerive wrote:
>
> Would someone be so kind as to take some measurements of the KAT100-1
> Antenna Tuner:
>
> The horizontal distance between the center of the Antenna 1 SO239 connector
> (J5) and the center of the Antenna 2 SO239 connector (J6).

1.41" +/- 0.03"
Note that this is also the distance from the center of the Antenna 1 SO239 
connector (J5) and the center of the Input SO239 connector (J4)

> The horizontal distance, parallel to the back panel, from the center of the
> Antenna 2 SO239 connector (J6) to a projection of the outer edge of the
> left side panel. In other words, how far in is the center of the Antenna 2
> SO239 connector from the outside edge of the left side panel?

To clarify the left panel is the panel as viewed from the front of the 
KAT100-1. The measurement does not include the height of the screw heads.
0.83" +/- 0.08"

> The horizontal distance, parallel to the back panel, between the center of
>  the Antenna 1 SO239 connector (J5) and the vertical center line of the
>  ground screw (E1).

2.33" +/- 0.08"
From the Input SO239 connector (J4): 0.92" +/- 0.08"

The slight error range in measurements will easily be accommodated by the 
short coax and ground wire connections of about 1 1/2 to 2 inches in length.
Thanks again and 73,
Darrell   VA7TO   K2#5093

-- 
Darrell Bellerive
Amateur Radio Stations VA7TO and VE7CLA
Grand Forks, British Columbia, Canada