[Elecraft] Fwd: KAT100-1 Measurements?

[Darrell Bellerive]

Resending this as I have not received any replies yet. Could anyone possibly 
help me out?

Thanks!

Darrell

----------  Forwarded Message  ----------

Subject: KAT100-1 Measurements?
Date: July 6, 2006 03:52 pm
From: Darrell Bellerive <va7to at rac.ca>
To: elecraft at mailman.qth.net

Would someone be so kind as to take some measurements of the KAT100-1 Antenna
Tuner:

The horizontal distance between the center of the Antenna 1 SO239 connector
(J5) and the center of the Antenna 2 SO239 connector (J6).

The horizontal distance, parallel to the back panel, from the center of the
Antenna 2 SO239 connector (J6) to a projection of the outer edge of the left
side panel. In other words, how far in is the center of the Antenna 2 SO239
connector from the outside edge of the left side panel?

The horizontal distance, parallel to the back panel, between the center of
 the Antenna 1 SO239 connector (J5) and the vertical center line of the
 ground screw (E1).

I am building a new feed-through panel and want to make it line up properly
with a KAT-100-1 which I have not yet purchased. There will be short runs (2
inches or so) of coax between the feed-through panel and the tuner, so the
measurements don't have to be exact. The coax will compensate for a slight
offset.

Thanks in advance!

Darrell   VA7TO   K2#5093

-------------------------------------------------------

-- 
Darrell Bellerive
Amateur Radio Stations VA7TO and VE7CLA
Grand Forks, British Columbia, Canada