[Elecraft] K2-S-Meter Alignment question

[JEAN-FRANCOIS MENARD]

No this is the VFO knob... turning the VFO knob when calibrate the S HI 
and S Lo paramater should be use to adjust the bar led display for 
proper receivng indication. If turning the VFO knob does nothing, you 
should probably have something wrong...


Gary Marks a écrit :
> Under S-Meter Alignment:
>
> The forth step says:
> Turn RF Gain fully counter-clockwise. Adjust the VFO knob until bargraph segment 9 lights, then turn it a bit more counter-clockwise until segment 10 just turns on (right-most segment).
>
> Question: Should this have said RF Gain instead of VFO knob ?  Turning the VFO does nothing while turning the RF Gain knob performs what the instructions say.
>
> Comments please......
>
> Gary
> WD8ICX
> K2 #5609 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>   
__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com