[Elecraft] K1 problem

[Alexandra Carter]

I'm working on one too, and the flat sides are printed on the board  
but you have to look close and use some imagination. There are also  
photos of the boards finished in the back of the manual. There's also  
looking at the schematic and seeing what connects to what, and  
finally some have built K1's and put photos of the boards on the net,  
you can look for that kind of info. Hope this is helpful, 73 de Alex  
NS6Y

On Jul 12, 2006, at 4:46 PM, Dr. Dan Swartling wrote:

> I am half-way through building my K1 #2222 and have hit a stumbling  
> block. How are trimmer caps C13 and C20 installed? On the revision  
> E board it is not obvious (to me) which way to orient the flat side.
>
> Dan
> -- 
> To make a difference, one must first be different.
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com