[Elecraft] K1 problem

[Alexandru Csete (OZ9AEC)]

On Wed, 12 Jul 2006 18:46:56 -0500 "Dr. Dan Swartling"
<dswart at tntech.edu> wrote:
> I am half-way through building my K1 #2222 and have hit a stumbling 
> block. How are trimmer caps C13 and C20 installed? On the revision E 
> board it is not obvious (to me) which way to orient the flat side.

Cool serial number!
I had the same problem. I looked them up in the parts placement
drawing at the back of the assembly manual and here I could clearly see
how they should be mounted. The flat side should face towards the back
of the PCB.

A rather bad picture, but this may help too:
http://www.oz9aec.dk/pictures/gal/Homebrew/Elecraft_K1/K1-0048.jpg


> 
> Dan

73 Alex OZ9AEC
K1 #2172