[Elecraft] Re: Transverter with Common IF

[wayne burdick]

Kent Tannery wrote:

> I am trying to use my K2/100 (K60XV transverter interface installed) 
> with a Down East Microwave 900mhz transverter which has only a 
> "common" IF (not a TX IF and RX IF).  The transverter requires low 
> power IF around 0.10 miliwatts.  (Transmitting has been tested and 
> works fine)
> The problem is that the DEMI transverter has a common IF and the K2 
> has seperate TX and RX IFs.

Kent,

You should be able to simply use a "Y" RCA adapter to tie the 
transverter IN and OUT jacks in parallel. Then route the resulting 
single cable to the transverter.

If this doesn't work, please let me know -- it should. It should also 
be documented in the XV series manual. If not, it was an oversight on 
my part. We'll add an errata item.

73,
Wayne
N6KR


---

http://www.elecraft.com