[Elecraft] Transverter with Common IF

[Dave Sublette]

Just use a G6Y relay and key it with an input from the K2 and switch the 
commom input of the transverter between T and R connectors of the K2 at 
the appropriate times. It is simpler than trying to modify the DEM 
transverter.

Dave, K4TO

Kent Tannery wrote:

>I am trying to use my K2/100 (K60XV transverter interface installed) with a Down East Microwave 900mhz transverter which has only a "common" IF (not a TX IF and RX IF).  The transverter requires low power IF around 0.10 miliwatts.  (Transmitting has been tested and works fine)
>   
>  The problem is that the DEMI transverter has a common IF and the K2 has seperate TX and RX IFs.  I phoned Elecraft today and they suggested trying to modify the transverter to pull the RX IF seperately.
>   
>  Anyone have any other solutions or ideas?
>   
>  KD5SHM
>  Kent
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com
>
>  
>